Official Content

It is automatically loaded when using the Error_Handler ruleError_Handler command, or New command.

Data Type:


Read the article about Error_Handler rule to check the values obtained by the variable depending on the error when using the Error_Handler rule or command.

When using the New command, if the primary key or any candidate key already exists, the &Err standard variable could be created and set to code = 1. Also, the &ErrMsg standard variable could be created; if so, it will contain the message associated with the corresponding error code contained in &Err.          

See Also

Err variable
Error_Handler rule
Error_Handler command
New command

Last update: November 2023 | © GeneXus. All rights reserved. GeneXus Powered by Globant